Troubleshooting - AEG 68476IU-MN User Manual

36 www.aeg.com
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
4. Install the glass cover.
11.9 Removing the drawer
WARNING!
Do not keep flammable
items (such as cleaning
materials, plastic bags, oven
gloves, paper or cleaning
sprays) in the drawer. When
you use the oven, the drawer
can become hot. There is a
risk of fire

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate the ap-
pliance.
You cannot activate the ap-
pliance.
You cannot activate or oper-
ate the hob.
You cannot activate or oper-
ate the hob.
You cannot activate or oper-
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The drawer below the oven can be
removed for cleaning.
1. Pull the drawer out until it stops.
2. Lift the drawer slightly, so that can be
lifted upwards at an angle of the
drawer guides.
To install the drawer, follow the
procedure in reverse.
Possible cause
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
The fuse is blown.
You touched 2 or more sen-
sor fields at the same time.
STOP+GO function oper-
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Touch only one sensor field.
Refer to "Hob - Daily use"
chapter.
Clean the control panel.
Remove the object from the
sensor fields.