AEG 10366MM-MN User Manual page 23

Problem
The flame extinguishes im-
mediately after ignition.
The flame ring is uneven.
The burners do not work.
The flame colour is orange
or yellow.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
The oven does not heat up.
The turnspit does not rotate. The turnspit is not correctly
It takes too long to cook the
dishes or they cook too
quickly.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
Thermocouple is not heated
up sufficiently.
Burner crown is blocked with
food residues.
There is no gas supply.
The lamp is defective.
You left the dish in the oven
for too long.
The necessary settings are
not set.
installed into the turnspit
hole.
The temperature is too low
or too high.
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
.........................................
.........................................
.........................................
ENGLISH
Remedy
After lightning the flame,
keep the spark generator ac-
tivated for equal or less than
10 seconds
Make sure that the injector is
not blocked and the burner
crown is clean.
Check the gas connection.
The flame can look orange
or yellow in some areas of
the burner. This is normal.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Make sure that the settings
are correct.
Refer to "Using the turn-
spit".
Adjust the temperature if
necessary. Follow the advice
in the user manual.
23