Troubleshooting - AEG 17166GT-MN User Manual

24 www.aeg.com
The back lamp
The lamp glass cover is at
the back of the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate the ap-
pliance.
You cannot activate the ap-
pliance.
You cannot activate the ap-
pliance.
The burners do not work.
There is no spark when you
try to activate the spark gen-
erator.
The flame extinguishes im-
mediately after ignition.
The flame ring is uneven.
The flame colour is orange
or yellow.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
2. Clean the glass cover.
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
4. Install the glass cover.
Possible cause
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
The fuse is released.
The appliance is too hot.
There is no gas supply.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heated
up sufficiently.
Burner crown is blocked with
food residues.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Wait for the appliance to
cool down.
Check the gas connection.
Place the burner cap and
crown correctly.
After lightning the flame,
keep the knob pushed for
equal or less than 10 sec-
onds.
Make sure that the injector is
not blocked and the burner
crown is clean.
The flame can look orange
or yellow in some areas of
the burner. This is normal.
Activate the oven.
Set the clock.
Make sure that the settings
are correct.