AEG 10366MM-MN User Manual page 28

28 www.aeg.com
To install all the accessories, do the first
step in an opposite sequence.
14.13 Backguard
Fix backguard B on the side holes C from
hob using a cross screwdriver and the
screws A.
C
14.14 Anti-tilt protection
Set the correct height and area for the
appliance before you attach the anti-tilt
protection.
CAUTION!
Make sure you install the
anti-tilt protection at the
correct height.
Make sure that the surface
behind the appliance is
smooth.
You must install the anti-tilt protection. If
you do not install it, the appliance can
tilt.
Your appliance has the symbol shown on
the picture (if applicable) to remind you
A
C
A
B
about the installation of the anti-tilt
protection.
1. Install the anti-tilt protection 325 -
330 mm down from the top surface
of the appliance and 110 - 115 mm
from the side of the appliance into
the circular hole on a bracket. Screw
it into the solid material or use
applicable reinforcement (wall).
2. You can find the hole on the left side
at the back of the appliance. Lift the
front of the appliance and put it in
the middle of the space between the
cupboards. If the space between the
bench cupboards is larger than the
width of the appliance, you must
adjust the side measurement to
centre the appliance.
110-115
mm
325-330
mm