Troubleshooting - AEG CCS6741ACM User Manual

2
1
2. Pull up the trim.
3. Remove the glass panels.
To replace the glass panels,
do the same steps in
reverse. Before you lower
the trim, attach the A trim
part to the door. Refer to the
image.

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate the ap-
pliance.
You cannot activate the ap-
pliance.
Residual heat indicator does
not come on.
You cannot activate the out-
er ring.
A
Possible cause
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
The fuse is blown.
The zone is not hot because
it operated only for a short
time.
11.8 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The back lamp
The lamp glass cover is at
the back of the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
4. Install the glass cover.
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Activate the inner ring first.
ENGLISH 27