Troubleshooting - AEG 49176V-MN User Manual

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate the ap-
pliance.
You cannot activate the ap-
pliance.
You cannot activate or oper-
ate the hob.
You cannot activate or oper-
ate the hob.
You cannot activate or oper-
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
Automatic Heat Up function
does not operate.
Automatic Heat Up function
does not operate.
You cannot activate the out-
er ring.
The sensor fields become
hot.
Possible cause
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
The fuse is released.
You touched 2 or more sen-
sor fields at the same time.
STOP+GO function oper-
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot because
it operated only for a short
time.
The zone is hot.
The highest heat setting is
set.
The cookware is too large or
you put it too near to the
controls.
ENGLISH
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Touch only one sensor field.
Refer to "Hob - Daily use"
chapter.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
Activate the inner ring first.
Put large cookware on the
rear zones if possible.
33