Viewing A Signal - Agilent Technologies PSA Series Getting Started Manual

Viewing a Signal

1. Press
2. Press
3. Connect the analyzer's rear panel
Setting Reference Level and Center Frequency
The display examples in this section are made using various analyzer models, you
NOTE
may see some variations depending upon your analyzer.
4. Set the reference level to 10 dBm: Press
5. Set the center frequency to 30 MHz: Press
Figure 3-1 10 MHz Internal Reference Signal and Associated Spectrum
Chapter 3
Preset . If the softkeys
.
Factory Preset
System , Reference
(underlined), press the softkey to toggle the reference on.
input.
, , .
Freq 30 MHz
The 10 MHz reference signal spectrum appears on the display, as shown in
Figure 3-1.
Making a Basic Measurement
Factory Preset and User Preset
, then note the 10 MHz Out
10 MHz OUT (SWITCHED)
AMPLITUDE
FREQUENCY
10 MHz
Viewing a Signal
appear, select
setting. If Off is active
to the front-panel
, 10, dBm .
,
Center
39