Saving a File
You can save files (setups, states, traces, limits, corrections, measurement results,
or screens) to a diskette (A:\), or the internal drive (C:\). In this example you will
save a trace to the internal C: drive.
Trace files are not bitmap files. Files saved as
NOTE
applications or converted. If you require the use of other applications, for example
Microsoft Word or Microsoft Excel, be sure to save your files as .gif or .wmf
formats using
Step 1. Set up the analyzer trace
1. Perform a factory preset by pressing
2. Turn on the internal 50 MHz alignment signal of the analyzer as follows:
3. Set the center frequency to 50 MHz by pressing
4. Set the span to 75 MHz by pressing
5. View trace 1 and put it into maximum hold by pressing
Chapter 4
for your file
Screen
• Press
,
Input/Output
,
.
50
MHz
signal will appear on the display.
(Trace 1 should already by underlined, but if not, press
underlined and then press
similar to
Figure
4-2.
Viewing Catalogs and Saving Files
Trace
.
Type
,
Preset
Factory Preset
,
.
Input Port
Amptd Ref
SPAN
,
Span
.) Your analyzer display should look
Max Hold
Saving a File
cannot be imported into other
(if present).
FREQUENCY
,
Center Freq
,
75
,
MHz
. The reference
View/Trace
,
Max Hold
Trace 1 2 3
until 1 is
,
.
51