Loading A File - Agilent Technologies PSA Series Getting Started Manual

Loading a file

1. Reset the analyzer by pressing
2. To access the Load menu, press
3. Select the type of file you want to load (setup, state, trace, limits, or
NOTE Not all file types can be loaded back into the analyzer. For example, Screen files
and CSV (comma separated value) files cannot be loaded. CSV and Screen files
are designed for use with a PC.
4. Select the directory where your file is located. In this example, select the
5. Select the file you want to load into the analyzer by moving the cursor with the
6. Press
Figure 4-5 File Loaded
Chapter 4
corrections). In this example you are loading a trace file; press
C:\START\ directory. (Use the front-panel step keys, knob,
Select keys to locate the directory.)
front-panel knob to highlight the file name. In this example, the file is
TEST1.TRC. Select the trace into which you wish to load the file. In this
example, load it into Trace 2. (
Load Now to load the specified file. Your display should look similar to
Figure 4-5. The status bar reads: C:\START\TEST1.TRC file loaded.
Viewing Catalogs and Saving Files
,
Preset Factory Preset
File , Load .
, ).
Destination Trace 2
Saving a File
(if present).
Type, Trace .
and/or
Dir Up, Dir
55