Viewing A Signal - Agilent Technologies ESA Series Getting Started Manual

Viewing a Signal

1. Press Preset . If the softkeys
2. Connect the analyzer's rear panel 10 MHz REF OUT to the front-panel input.
Setting Reference Level and Center Frequency
NOTE
The display examples in this section are made using various analyzer models, you
may see some variations depending upon your analyzer.
3. Set the reference level to 10 dBm: Press
4. Set the center frequency to 30 MHz: Press
The 10 MHz reference signal spectrum appears on the display, as shown in
NOTE
The display examples in this book are made using various analyzer models, you
may see some variations depending upon your analyzer.
Figure 3-1 10 MHz Internal Reference Signal and Associated Spectrum
Chapter 3
Factory Preset and User Preset
AMPLITUDE
FREQUENCY

10 MHz
Making a Basic Measurement
appear, select Factory Preset
, 10, dBm .
, Center Freq , 30 , MHz
Figure
Viewing a Signal
.
.
3-1. 
43