Connecting to external equipment
Also, the [CLOCK IN] terminal supports audio-click (metronome) input,
audio-trigger control that plays a sequence of the unit in one step
increments, and GATE control that plays sequence information only
while control signals are being input.
Connecting
• Connect the [CLOCK OUT] terminal of this unit to the CLOCK IN
terminal of the connected device.
• Connect the [CLOCK IN] terminal of this unit to the CLOCK OUT
terminal of the connected device.
• Use a stereo mini-jack cable for this connection.
The signals shown below are assigned to the pins of a stereo mini-
jack cable connected to the [CLOCK IN] terminal or [CLOCK OUT]
terminal.
(1) Sleeve: GND, (2) Ring: Start/Stop, (3) Tip: clock
• By connecting Ring and Tip to PIN1 (Start/Stop) and PIN3 (Clock) of
the [DIN SYNC] terminal and setting [OUT Sync Mode] or [IN Sync
Mode] of the [CLOCK] setting in the GLOBAL menu to [24ppqn] or
[48ppqn], you can connect the CLOCK terminal on this unit to the
DIN SYNC terminal of a DIN SYNC-compatible device.
166
En