PIONEER DJ Toraiz Squid Operating Instructions Manual page 157

Connecting to external equipment
When using the unit as a slave device
By setting [Sync Source] of [Sync Common] setting in the GLOBAL
menu to the connecting terminal of an external master device and
sending the timing clock to the unit, you can use the unit as a slave
device.
By setting the unit as a slave device, you can play a sequence at the
same BPM as an external master device and control playing back and
stopping of the synchronized playing by operating the unit or the
external device connected to the [MIDI IN] terminal, [USB-B] terminal,
or the timing clock input terminal set in [Sync Source] on the unit.
The received timing clock can be converted and output from the
following terminals.
• [DIN SYNC OUT1] terminal
• [DIN SYNC IN/OUT2] terminal
• [CLOCK OUT] terminal
For the settings of the timing clock rate from each terminal, refer to the
[DIN SYNC] setting (page 125) or [CLOCK] setting (page 128) in the
GLOBAL menu.
Notes
• If you set [Sync Source] to a state other than [DIN MIDI] or [USB
MIDI], refer to "Synchronizing the unit and an external DIN SYNC
compatible device to play" (page 160) and "Synchronizing the unit
with an external CLOCK compatible device to play" (page 165).
• Depending on the external device to be connected, the BPM
displayed on the unit and the external device may be different.
157
En