PIONEER DJ Toraiz Squid Operating Instructions Manual page 126

 OUT1 Cont/Rst Start
Setting value: Disable*, Enable
Set the Continue/Reset Start signal output to Disable/Enable from the
[DIN SYNC OUT1] terminal.
Check the specification of the connected equipment and select an
appropriate value.
• Disable: The Continue/Reset Start signal is not output when
playback starts.
Only the timing clock and Start/Stop signal is output from the [DIN
SYNC OUT1] terminal.
• Enable: The Continue/Reset Start signal is output when playback
starts.
For details on Continue Start and Reset Start signals, refer to
"Synchronizing the unit and an external DIN SYNC compatible device
to play" (page 160).
 OUT2 Mode
Setting value: IN*, OUT
Set the [DIN SYNC IN/OUT2] terminal to the input terminal ([IN]) or
output terminal ([OUT]).
 OUT2 Sync Mode
Setting value: Sync24*, Sync48
Set the timing clock rate signal to/from the [DIN SYNC IN/OUT2]
terminal. Check the specification of the connected equipment and
select an appropriate value. For details on the setting value, refer to
"OUT1 Sync Mode" (page 125).
Note
If you change the DIN SYNC setting during sequence playback, the
sequence playback will stop.
Changing the settings
126
En