Table of Contents
Advertisement
Checking the Configuration
Using the show diag Command
Display the types of port adapters installed in your system (and specific information about each) using
the show diag slot command, where slot is the port adapter slot in a Cisco 7100 series router, Cisco 7200
series router, Cisco 7301 router, and Cisco 7401ASR router and the interface processor slot in a Cisco
7000 series router or Cisco 7500 series router with a VIP. In the Cisco 7304 PCI Port Adapter Carrier
Card in a Cisco 7304 router, slot is the router module-slot-number. The following examples show output
for some of the supported platforms.
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
Cisco 7200 Series Routers
Following is an example of the show diag slot command that shows a PA-MC-2T3+ in port adapter slot
5 of a Cisco 7200 series router:
The example that follows is for a port adapter in slot 5 of the Cisco 7200 router series:
Router# show diag 5
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
4-22
[biff-mc2t3h 293]
7513_1 uptime is 4 days, 6 hours, 11 minutes
System returned to ROM by reload
cisco RSP2 (R4700) processor with 131072K/2072K bytes of memory.
R4700 CPU at 100Mhz, Implementation 33, Rev 1.0
Last reset from power-on
G.703/E1 software, Version 1.0.
G.703/JT2 software, Version 1.0.
Channelized E1, Version 1.0.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Bridging software.
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.1.
Chassis Interface.
1 EIP controller (4 Ethernet).
1 HIP controller (1 HSSI).
1 FSIP controller (8 Serial).
1 AIP controller (1 ATM).
1 TRIP controller (4 Token Ring).
1 FIP controller (1 FDDI).
2 VIP2 R5K controllers (2 E1)(2 Channelized T3).
4 Ethernet/IEEE 802.3 interface(s)
4 Token Ring/IEEE 802.5 interface(s)
66 Serial network interface(s)
1 HSSI network interface(s)
1 FDDI network interface(s)
1 ATM network interface(s)
2 Channelized T3 port(s)
123K bytes of non-volatile configuration memory.
16384K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
16384K bytes of Flash PCMCIA card at slot 1 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
No slave installed in slot 7.
Configuration register is 0x0
Chapter 4
Configuring Unchannelized mode for the Cisco PA-MC-2T3+
OL-3526-05
Advertisement
Table of Contents
