Table of Contents
Advertisement
Chapter 4
Configuring Unchannelized mode for the Cisco PA-MC-2T3+
Table 4-3
Using show Commands (continued)
Command
For a Cisco 7304 PCI Port Adapter Carrier Card in
a Cisco 7304 router:
show interfaces serial port-adapter/t3-port
For Cisco 7301 routers:
show interfaces serial port-adapter/t3-port
For Cisco 7401ASR routers:
show interfaces serial port-adapter/t3-port
For Cisco 7500 series routers:
show interfaces serial slot/port-adapter/t3-port
show protocols
show running-config
show startup-config
If an interface is shut down and you configured it as up, or if the display indicates that the hardware is
not functioning properly, ensure that the interface is properly connected and terminated. If you still have
problems bringing up the interface, contact a service representative for assistance. This section includes
the following subsections:
•
•
•
•
Choose the subsection appropriate for your system. Proceed to the
Network Connectivity" section on page 4-30
Using the show version or show hardware Commands
Display the configuration of the system hardware, the number of each interface type installed, the Cisco
IOS software version, the names and sources of configuration files, and the boot images, using the show
version (or show hardware) command. Following are examples for some of the platforms.
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
OL-3526-05
Function
Displays status information
about a specific type of
interface
Displays status information
about a specific type of
interface
Displays status information
about a specific type of
interface
Displays status information
about a specific type of
interface (for example,
serial) on a VIP in a Cisco
7000 series or Cisco 7500
series router
Displays protocols
configured for the entire
system and for specific
interfaces
Displays the running
configuration file
Displays the configuration
stored in NVRAM
Using the show version or show hardware Commands, page 4-19
Using the show diag Command, page 4-22
Using the show interfaces Command, page 4-24
Using the show controllers Command, page 4-27
when you have finished using the show commands.
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
Checking the Configuration
Example
Router# show interfaces serial 3/1
Router# show interfaces serial 3/1
Router# show interfaces serial 3/1
Router# show interfaces serial 3/1/0
Router# show protocols
Router# show running-config
Router# show startup-config
"Using the ping Command to Verify
4-19
Advertisement
Table of Contents
