Configuring a Channelized T3 Link
Configuring the T3 Controller
This section provides procedures and examples for configuring the T3 controller on the PA-MC-2T3+,
and includes information on the following topics:
•
•
•
•
•
•
•
•
•
•
Selecting a T3 Controller
You must enter the following controller command, before any other configuration commands, to select
the T3 controller you want to configure:
controller T3 interface-processor-slot/port-adapter-slot/T3-port for Cisco 7500 series router
controller T3 chassis-slot/T3-port for Cisco 7301 router\
controller T3 chassis-slot/T3-port for Cisco 7401ASR router
controller T3 chassis-slot/T3-port for Cisco 7200 series router
Examples of selecting the T3 controller follow:
•
•
Setting Channelized Mode for the T3 Controller
Channelized mode is the default, so you only need to configure the T3 for channelized mode if it had
Note
previously been set to 'no channelized' mode.
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
5-4
Selecting a T3 Controller, page 5-4
Setting Channelized Mode for the T3 Controller, page 5-4
Setting the Framing Type for the T3 Controller, page 5-5
Specifying the Cable Length for the T3 Controller, page 5-6
Setting the Clock Source for the T3 Controller, page 5-6
Configuring MDL Messages for the T3 Controller, page 5-7
Examples of MDL Message Configuration, page 5-7
Configuring the Loopback Mode for the T3 Controller, page 5-8
Shutting Down the T3 Controller, page 5-9
Configuring T1 Lines, page 5-10
The example that follows is for a port adapter on a VIP in interface processor slot 1:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# controller t3 1/0/0
Router(config-controller)#
The example that follows is for a port adapter in slot 1 of the Cisco 7200 series routers:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# controller t3 1/0
Router(config-controller)#
Chapter 5
Configuring Channelized mode for the Cisco PA-MC-2T3+
OL-3526-05