Cisco PA-MC-2T3+ Installation And Configuration Manual page 6

Contents
Checking the Configuration
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
vi
Examples of MDL Message Configuration
Configuring the Loopback Mode for the T3 Controller
Configuring the T3 controller to Enable Remote Loopback
Shutting Down the T3 Controller
Configuring T1 Lines
5-10
Creating a Logical Channel Group on a T1 Line
Removing a Logical Channel Group from a T1 Line
Setting the Framing Format on a T1 Line
Setting the Yellow Alarm Configuration for a T1 Line
Setting the Clock Source on a T1 Line
Setting the FDL Configuration for a T1 Line
Setting Loopbacks on a T1 Line
Configuring a BER Test on a T1 Line
Sending a BER Test Pattern on a T1 Line
Viewing the Results of a BER Test
Terminating a BER Test
Performing a Basic Serial Interface Configuration
5-26
Using show Commands to Verify the New Interface Status
Using the show version or show hardware Commands
Using the show diag Command
Using the show interfaces Command
Using the show controllers Command
Displaying Remote Performance Reports
Using the ping Command to Verify Network Connectivity
5-7
5-9
5-10
5-11
5-11
5-12
5-13
5-13
5-16
5-17
5-18
5-23
5-24
5-31
5-33
5-35
5-42
5-8
5-9
5-12
5-26
5-27
5-44
OL-3526-05