Using The Show Diag Command - Cisco PA-2CE1 Series Installation And Configuration Manual

Checking the Configuration

Using the show diag Command

Display the types of port adapters installed in your system (and specific information about each) using
the show diag slot command, where slot is the port adapter slot in a Cisco 7200 series router and the
interface processor slot in a Cisco 7000 series or Cisco 7500 series router with a VIP2.
Note The ouputs that appear in this document may not match the output you receive when
running these commands. The outputs in this document are examples only.
Cisco 7200 Series Routers
Following is an example of the show diag slot command that shows a PA-2CE1 in port adapter slot 1:
Router# show diag 1
Slot 1:
PA-2CE1 Channelized E1 Port Adapter Installation and Configuration
4-16
Channelized E1 port adapter, 2 ports
Port adapter is analyzed
Port adapter insertion time 02:18:20 ago
Hardware revision 255.255
Serial number 4294967295
Test history 0xFF
EEPROM format version 255
EEPROM contents (hex):
0x20: FF 06 FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Board revision UNKNOWN
Part number 255-65535-255
RMA number 255-255-255
Chapter
OL-3519-01