Download  Print this page

Cisco 7304 Pci Port Adapter Carrier Card-removing And Installing A Port Adapter - Cisco PA-MC-2T3+ Installation And Configuration Manual

Multi-channel t3 port adapter.
Hide thumbs

Advertisement

Chapter 3
Removing and Installing Port Adapters
Cisco 7304 PCI Port Adapter Carrier Card—Removing and Installing a Port
Adapter
You can install one single-width port adapter in a Cisco 7304 PCI Port Adapter Carrier Card. This
section provides step-by-step instructions for removing and installing a port adapter in a Cisco 7304 PCI
Port Adapter Carrier Card.
Warning
When performing the following procedures, wear a grounding wrist strap to avoid ESD damage to the
Cisco 7304 PCI Port Adapter Carrier Card. Some platforms have an ESD connector for attaching the wrist
strap. Do not directly touch the midplane or backplane with your hand or any metal tool, or you could
shock yourself.
To remove and install a port adapter in a Cisco 7304 PCI Port Adapter Carrier Card, refer to
and do the following:
If the Cisco 7304 PCI Port Adapter Carrier Card is still in the router, you must remove the Cisco 7304
Step 1
PCI Port Adapter Carrier Card before removing a port adapter.
To remove the port adapter from the Cisco 7304 PCI Port Adapter Carrier Card, turn the port adapter
Step 2
lock from its locked and horizontal position shown in A of
position shown in B of
Grasp the handle of the port adapter and pull the port adapter from the Cisco 7304 PCI Port Adapter
Step 3
Carrier Card. (You have already disconnected the cables from the port adapter when removing the
Cisco 7304 PCI Port Adapter Carrier Card).
Step 4
To insert the port adapter in the Cisco 7304 PCI Port Adapter Carrier Card, locate the guide rails inside
the Cisco 7304 PCI Port Adapter Carrier Card that hold the port adapter in place. They are at the top
left and top right of the port adapter slot and are recessed about an inch, as shown in C of
Carefully slide the port adapter in theCisco 7304 PCI Port Adapter Carrier Card until the port adapter
Step 5
makes contact with the port adapter interface connector. When fully seated, the port adapter front panel
should be flush with the face of the Cisco 7304 PCI Port Adapter Carrier Card.
After the port adapter is properly seated, turn the port adapter lock to its locked and horizontal position,
Step 6
as shown in A of
OL-3526-05
Figure
3-5.
Figure
3-5.
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
Port Adapter Removal and Installation
Figure 3-5
to its unlocked and vertical
Figure 3-5
Figure
3-5.
3-9

Advertisement

Table of Contents

   Related Manuals for Cisco PA-MC-2T3+

Comments to this Manuals

Symbols: 0
Latest comments: