Table of Contents
Advertisement
Chapter 1
Overview
VIP Interface Addresses
This section describes how to identify the interface addresses used for the PA-MC-2T3+ on a VIP in
Cisco 7000 series and Cisco 7500 series routers.
Although the processor slots in the 7-slot Cisco 7000 and Cisco 7507 and the 13-slot Cisco 7513 and
Note
Cisco 7576 are vertically oriented and those in the 5-slot Cisco 7010 and Cisco 7505 are horizontally
oriented, all Cisco 7000 series and Cisco 7500 series routers use the same method for slot and port
numbering.
See
three-part number in the format
interface-processor-slot-number/port-adapter-slot-number/interface-port-number.
If the VIP is inserted in interface processor slot 3, then the interface addresses of the PA-MC-2T3+ are
3/1/0 through 3/1/1 (interface processor slot 3, port adapter slot 1, and interfaces 0 and 1). If the
port adapter was in port adapter slot 0 on the VIP, these same interface addresses would be numbered
3/0/0 through 3/0/1.
If you remove the VIP with the PA-MC-2T3+ (shown in
Note
processor slot 3 and install it in interface processor slot 2, the interface addresses become 2/1/0 through
2/1/1.
OL-3526-05
Table 1-4 on page 1-11
for the interface address format. The interface address is composed of a
Figure 1-9 on page
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
Identifying Interface Addresses
1-9) from interface
1-13
Advertisement
Table of Contents
