Table of Contents
Advertisement
Chapter 5
Configuring Channelized mode for the Cisco PA-MC-2T3+
VIP in Cisco 7000 Series or Cisco 7500 Series Routers
Following is an example of the show interfaces command used with the VIP. In this example, a VIP is
in interface processor slot 1, and the PA-MC-2T3+ is in port adapter
slot 0.
Using the show controllers Command
You can display information for all T1 lines within a PA-MC-2T3+ with the command:
show controllers T3 slot/port-adapter/port [brief | tabular | remote performance]
where:
•
•
•
If you use the show controllers T3 slot/port-adapter/port command without either of the three optional
Note
arguments (brief, tabular, or remote performance), all information is displayed for the T3 controller
you specified; therefore, the resulting display output can be extensive.
OL-3526-05
18722 packets input, 2134308 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
82 input errors, 0 CRC, 0 frame, 82 overrun, 0 ignored, 0 abort
18722 packets output, 2134308 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffers copied, 0 interrupts, 0 failures
8 carrier transitions no alarm present
Timeslot(s) Used: 1-24, Transmitter delay is 0 flags, transmit queue length 5
non-inverted data
Router# show interfaces serial 1/0/0/1:0
Serial1/0/0/1:0 is up, line protocol is up
Hardware is 2CT3+
Internet address is 1.1.1.1/24
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
Last input 19:04:01, output 12:49:52, output hang never
Last clearing of "show interface" counters 13:09:09
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
18722 packets input, 2134308 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
82 input errors, 0 CRC, 0 frame, 82 overrun, 0 ignored, 0 abort
18722 packets output, 2134308 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffers copied, 0 interrupts, 0 failures
8 carrier transitions no alarm present
Timeslot(s) Used: 1-24, Transmitter delay is 0 flags, transmit queue length 5
non-inverted data
brief displays a list of configurations only.
tabular displays a list of configurations and MIB data in a tabular format.
remote performance displays a list of performance data from the remote end of a T1 connection.
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
Checking the Configuration
5-35
Advertisement
Table of Contents
