Cisco PA-MC-2T3+ Installation And Configuration Manual page 80

Checking the Configuration
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is autonegotiation, media type is SX
output flow-control is off, input flow-control is off
ARP type:ARPA, ARP Timeout 04:00:00
Last input 18:56:46, output 00:00:09, output hang never
Last clearing of "show interface" counters 19:00:52
Input queue:0/75/16176489/0 (size/max/drops/flushes); Total output drops:0
(display text omitted)
GigabitEthernet0/2 is up, line protocol is up
Hardware is BCM1250 Internal MAC, address is 0005.dd2c.7c19 (bia 0005.dd2c.7c19)
Internet address is 1.1.1.1/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is autonegotiation, media type is SX
output flow-control is off, input flow-control is off
ARP type:ARPA, ARP Timeout 04:00:00
Last input 00:04:42, output 00:00:01, output hang never
Last clearing of "show interface" counters 19:00:54
Input queue:0/75/22087/0 (size/max/drops/flushes); Total output drops:0
(display text omitted)
Cisco 7401ASR Routers
Following is an example of the show interfaces serial command for Cisco 7401ASR routers. In this
example, the port adapter is in slot 1 of the Cisco 7401ASR router:
Router# show interfaces serial 1/0
Serial1/0 is up, line protocol is down
Hardware is PA-MC-2T3+
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
DSU mode 0, bandwidth 44210, scramble 0
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
4-26
reliability 255/255, txload 5/255, rxload 6/255
reliability 255/255, txload 1/255, rxload 5/255
reliability 128/255, txload 1/255, rxload 1/255
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
5823 packets output, 140669 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
1 carrier transitions
Chapter 4 Configuring Unchannelized mode for the Cisco PA-MC-2T3+
OL-3526-05