Table of Contents
Advertisement
Chapter 4
Configuring Unchannelized mode for the Cisco PA-MC-2T3+
VIP in Cisco 7000 Series or Cisco 7500 Series Routers
Following is an example of the show interfaces serial command used with a VIP in interface processor
slot 1 and a PA-MC-2T3+ in port adapter slot 0.
Router# show interfaces serial 1/0/0
Serial1/0/0 is up, line protocol is up
Hardware is cyBus 2CT3+ Serial
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Last input 00:00:09, output 00:00:07, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 4 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
DSU mode 0, bandwidth 44210, scramble 0
Using the show controllers Command
You can display information for the T3 controller within a PA-MC-2T3+ in Cisco 7200 series,
Cisco 7301 routers, and Cisco 7401ASR routers with the command:
show controllers t3 port-adapter/t3-port [brief | tabular]
where:
•
•
If you use the show controllers t3 port-adapter/port command without either of the optional arguments
Note
(brief or tabular), all information is displayed for the T3 controller you specified; therefore, the
resulting display output can be extensive.
Note
You can use these show controllers t3 commands for Cisco 7500 series routers in which the
PA-MC-2T3+ is supported. The syntax is as follows:
— show controllers t3 slot/port-adapter/t3-port brief
— show controllers t3 slot/port-adapter/t3-port tabular
OL-3526-05
reliability 255/255, txload 1/255, rxload 1/255
4 packets input, 402 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 1 abort
5 packets output, 1008 bytes, 0 underruns
0 output errors, 0 applique, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
brief displays a list of configurations only.
tabular displays a list of configurations and MIB data in a tabular format.
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
Checking the Configuration
4-27
Advertisement
Table of Contents
