Checking The Configuration; Using Show Commands To Verify The New Interface Status - Cisco PA-MC-2T3+ Installation And Configuration Manual

Checking the Configuration

Write the new configuration to NVRAM as follows:
Step 8
Router# copy running-config startup-config
[OK]
Router#
This completes the procedure for creating a basic configuration.
Checking the Configuration
After configuring the new interface, use the show commands to display the status of the new interface
or all interfaces, and use the ping and loopback commands to check connectivity. This section includes
the following subsections:
•
•
•

Using show Commands to Verify the New Interface Status

Table 5-3
and operating correctly and that the PA-MC-2T3+ appears in them correctly. Sample displays of the
output of selected show commands appear in the sections that follow. For complete command
descriptions and examples, refer to the publications listed in the
page
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Table 5-3 Using show Commands
Command
show version or
show hardware
show controllers
show diag slot
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
5-26
Using show Commands to Verify the New Interface Status, page 5-26
Displaying Remote Performance Reports, page 5-42
Using the ping Command to Verify Network Connectivity, page 5-44
demonstrates how you can use the show commands to verify that new interfaces are configured
viii.
Function
Displays system hardware
configuration, the number of
each interface type installed,
Cisco IOS software version,
names and sources of
configuration files, and boot
images
Displays all the current interface
processors and their interfaces
Displays types of port adapters
installed in your system and
information about a specific
port adapter slot, interface
processor slot, or chassis slot
Chapter 5 Configuring Channelized mode for the Cisco PA-MC-2T3+
"Related Documentation" section on
Example
Router# show version
Router# show controllers
Router# show diag 2
OL-3526-05