Table of Contents
Advertisement
Chapter 4
Configuring Unchannelized mode for the Cisco PA-MC-2T3+
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
Cisco 7200 Series Routers
Following is an example of the show interfaces serial command for Cisco 7200 series routers. In this
example, the port adapter is in slot 5 of the Cisco 7200 series router:
Router# show interfaces serial 5/0
Serial5/0 is up, line protocol is down
Hardware is PA-MC-2T3+
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
DSU mode 0, bandwidth 44210, scramble 0
Cisco 7301 Router
Following is an example of the
information for each interface is omitted. (Interfaces are administratively shut down until you enable
them.)
outer# show interfaces
GigabitEthernet0/0 is up, line protocol is up
Hardware is BCM1250 Internal MAC, address is 0005.dd2c.7c1b (bia 0005.dd2c.7c1b)
Internet address is 10.1.3.153/16
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 100Mb/s, media type is RJ45
output flow-control is off, input flow-control is off
ARP type:ARPA, ARP Timeout 04:00:00
Last input 00:00:01, output 00:00:07, output hang never
Last clearing of "show interface" counters 19:00:50
Input queue:0/75/63658/0 (size/max/drops/flushes); Total output drops:0
(display text omitted)
GigabitEthernet0/1 is up, line protocol is up
Hardware is BCM1250 Internal MAC, address is 0005.dd2c.7c1a (bia 0005.dd2c.7c1a)
Internet address is 192.18.1.1/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
OL-3526-05
reliability 128/255, txload 1/255, rxload 1/255
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
5823 packets output, 140669 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
1 carrier transitions
show interfaces
reliability 255/255, txload 1/255, rxload 1/255
command for Cisco 7301 routers. Most of the status
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
Checking the Configuration
4-25
Advertisement
Table of Contents
