Attaching a 2CT1 Interface Cable
On a single 2CT1 port adapter, you can use up to two serial connections.
Use the following procedure to connect a 2CT1 interface cable:
Step 1
Figure 13
Step 2
This completes the procedure for attaching a 2CT1 interface cable.
Attach the cable directly to the receptacle on the 2CT1 port adapter and tighten the
strain-relief screws. (See Figure 13.)
Port adapters have a handle attached, but this handle is not shown to allow a
Note
detailed view of each port adapter's faceplate.
Connecting a 2CT1 Interface Cable (CT1 Port Adapter Front View—Shown
without Handle)
To PRI CSU
Attach the network end of the cable to your Primary Rate Interface (PRI) channel service
unit (CSU) and tighten the strain-relief screws.
Strain-relief screw
Channelized T1 Port Adapter Installation and Configuration
Attaching a 2CT1 Interface Cable
17