Table of Contents
Advertisement
4.10 Log Set Installation Instructions
With door removed, carefully remove the log set foam pack from inside the firebox.
Cut the clear tapes and outer plastic wrap using a sharp utility knife or equivalent. Locate the 2 bags of coals and the
log pieces. Identify each log piece, A-F and the Large Chunk coals and Small coals per the diagrams on this page:
1.
Place Log "A" on rear shelf. Two pins protruding down from Log #A slide through two holes on rear shelf.
2.
Place Log B between rear burner tube and front burner tube, to the right side of pilot light assembly. Slide Log #B to
the right until log #B's right tip touches curve in burner tube. as shown below.
85-03-01071
D30 DEEP TIMBER
Page 57
Hide quick links:
Advertisement
Chapters
Table of Contents
