Table of Contents
Advertisement
DXV-35 DT4 DEEP TIMBER LOG SET INSTALLATION INSTRUCTIONS
FOLLOW EACH STEP DEPICTED IN THE DIAGRAMS, BELOW, TO INSTALL THE LOG SET.
CAUTION: LOGS ARE FRAGILE, HANDLE LOG PIECES WITH CARE.
Carefully unpack 9-piece log set, bag of coals and bag of inswool. NOTE: Logs are very fragile, handle with
care. Break packaging foam if log pieces are trapped within foam. Do not pull on logs!
Coals must not block pilot or burner flames! Placement of coals has a big effect on front burner flame ap-
pearance and "glow" of coals. More coals = less yellow flame and more glow. Fewer coals = more yellow
flame and less "glow".
Heat can be reduced by lowering flame height by turning the HI-LO knob. Blowers can also be turned down to
reduce heat output.
Do Not "over fire" by increasing Gas Input Rate above Rating Plate specifications.
Do Not turn down pilot flame length less than 1 inch long.
DXV35 DT4 LOG SET PARTS IDENTIFICATION
(COALS AND INSWOOL BAGS ARE NOT SHOWN HERE)
f i r e - p a r t s . c o m
26
Advertisement
Table of Contents
