Preparing For Installation - Mendota D30 Installation And Operating Instructions Manual

4.2 Preparing For Installation

Unpacking the Fireplace insert
The Fireplace Insert arrives from the factory on a wooden pallet with a cardboard box encasing the pallet and Fireplace insert.
To remove the outer box, identify and remove four Philips head drywall screws that secure a cardboard L pincher at the bottom
of each corner of the box.
Lift the outer box vertically straight upward until lower edge of the box clears the top of the unit body. Set the box aside.
Mendota recommends recycling the outer box.
Figure 4-1 Outer Box Removal
85-03-01071 D30 DEEP TIMBER Page 42