How To Remove Door - Mendota D30 Installation And Operating Instructions Manual

4.4 HOW TO REMOVE DOOR

1. Place both thumbs on lower doorframe directly above Spring Loaded Door Holding Bar.
2. Reach fingers under Bar and pull Bar straight out from Fireplace insert front.
3. Pull Bar down and move Bar inward until Bar clears doorframe - then release.
4. Repeat procedure for opposite Holding Bar.
5. Carefully lift door straight up until doorframe "clears" the 3 Door Holding Tabs on top of firebox.
6. Pull door directly out from firebox front
Door is now free from unit.
NOTE: Always check glass gasket condition and
gasket seal any time the glass door is removed
and when reinstalling glass door.
How To Replace Door
1. Center door in firebox opening. Move door
inward until the 3 slots on doorframe are
directly above the 3 Door Holding Tabs on
firebox top.
2. Lower door so the 3 Tabs on firebox top fit
through the 3 slots on the doorframe. (i.e.
"Hang" door on the 3 Tabs)
3. "Swing in" the lower edge of door until it
touches lower firebox front.
4. Pull Holding Bar down and outward (away from
Fireplace insert) until it clears doorframe.
5. Raise Bar until it fits securely in Bar Holding
Brackets on doorframe.
6. Repeat procedure for opposite Holding Bar.
Door is now connected and sealed to unit.
85-03-01071 D30 DEEP TIMBER
Figure 4-5 Door Operation
Page 45