T Oturn Off Gas Tof; Ireplace Insert - Mendota D30 Installation And Operating Instructions Manual

10 To reduce heat output, turn Hi/Lo Knob counterclockwise to desired temperature (see Figure 5-1 Gas Valve). Blower speed
can also be turned down to reduce heat distribution.
NEVER "over fire" by increasing BTUH above Serial Number Plate specifications.
NEVER turn down (reduce) pilot flame below the minimum 325 millivolts.
11 Open windows for first two hours of operation.
NOTICE: Initial start -up will cause some NON -TOXIC "off gassing" of adhesives, binder s, paint, etc. Most
nuisance odors will be
eliminated after the first 2 hrs. of operation, however, slight amounts may be present during the first 24
hrs.
5.5 TO TURN OFF GAS TO FIREPLACE INSERT
1.
Turn "OFF" the wall thermostat or timer control device. Pilot will remain lit for return to normal service.
2. For complete shutdown turn Gas Cock Dial to "OFF".
3.
Turn off the internal manual shutoff valve in the appliance. See
85-03-01071
3.6.6 Factory Installed Manual Gas Shutoff
D30 DEEP TIMBER
Valve.
Page 65