Mendota D30 Installation And Operating Instructions Manual page 43

Contents of the Manual Packet
Once the outer box is removed, you will find the Fireplace insert body and a manual packet. This manual packet includes the
items shown in the table, below. Contact Mendota Technical Service if any parts are missing.
Owner's Manual.
Must Leave with Homeowner.
3/8-16 x 2-1/2" Bolts (Qty 4) #05-01-00112
What is included with this Appliance?
A red brick firebox liner and a premium fiber log set are included with this appliance. The liner is factory installed inside the
firebox. The log set is contained within a foam packaging and placed inside the firebox.
A manual On/Off switch is included and wired into the ignition system of this appliance.
What is not included with this Appliance?
Decorative fronts are not included with this base Fireplace insert product. One of many decorative Fronts options must be
selected and purchased separately.
A wall thermostat is not included.
Unbolting Fireplace insert from Pallet
The Fireplace Insert body is bolted to the pallet top surface using 5/16" X 1" Lag Screws through shipping clips. One on each side
and one or more at the rear. Use a 1/2" socket and wrench to remove the lag screws and detach fireplace insert from the pallet
top.
85-03-01071
This Manual
Figure 4-2 Manual Packet Contents
Figure 4-3 Unbolting Unit from Pallet
D30 DEEP TIMBER Page 43