Drying Result - Bosch SRU53E05AU Repair Instructions

7.5

Drying result

Customer complaint
Not drying correctly
815_58300000120057_ara_en_d.doc – 25.05.11
Cause
No rinse aid in the dispensing device
Appliance not heating
Programme selected without drying cycle
The rinse aid integrated in tablets has dissolved too early
Plastic parts
Remedial action
Advise customer
Check heating circuit according to circuit diagrams,
note pressure switch on the instantaneous water
heater (the circulation pump cannot build up adequate
pressure if there is insufficient water in the appliance).
Advise customer, quick programme is without drying
cycle, drying level option has been set too low
Advise customer, tablet is unsuitable for this
programme
Plastics retain very little heat and have a hydrophobic
surface which is difficult to moisten. As a result,
droplets will form during drying.
Seite 56 von 60