2
INSTALLATION
2.1
Aligning the appliance
To ensure a perfect locking function and prevent leaks in the area of
the door, the appliance must be aligned precisely via the height-
adjustable feet. If the appliance is integrated, the middle rear height-
adjustable foot can be adjusted from the front.
When installing the appliance, please note:
►
Using the height-adjustable feet, raise the appliance
until the housing touches the worktop.
►
The installation instructions (drilling template) are re-
quired for attaching the furniture front to integrated
and fully integrated appliances.
►
The tensile force of the door springs in integrated
and fully integrated appliances can be adjusted to
the weight of the furniture door
point).
►
To prevent injury, a side cover 481271 can be fitted
near the hinges of appliances which are fitted to the
end, built in or under or are free-standing.
2.2
Electrical connection
Connect the appliance to a correctly installed earthed socket only.
Comply with the specifications on the rating plate.
815_58300000120057_ara_en_d.doc – 25.05.11
2.3
If the appliance is connected to the drain with the standard hose
length, the max. permitted height from the floor is 90 cm. If the drain-
age hose is extended, a max. height of 80 cm must not be exceeded.
The water connection (
a water pressure of at least 0.5 bar (0.5 at.) (when the tap is turned
on, the water flow rate must be more than 8 l/min.). If the water
pressure is more than 10 bar (10 at.), a pressure reducing valve must
be in-stalled.
The appliances can be connected to warm water up to 60 °C. How-
ever, it is recommended to connect the appliance to cold water (better
drying and washing results).
Connection dimensions for all 45 cm dishwashers
(See Door spring
a
1.4 m
b
1.7 m
c
1.3 m (3.5 m with extension set)
Water connection
3
/
inch) requires a conventional water line with
4
d
e
f
1.4 m (3.6 m with extension set)
1.5 m (3.5 m with extension set)
1.4 m (3.4 m with extension set)
Seite 4 von 60