Drying Result - Bosch GV 630 S Repair Instructions

7.6

Drying result

Customer complaint Cause
Not drying correctly No rinse aid in the dispensing device
Appliance connected to hot water, appliance is suitable for
hot-water connection, but not recommended.
Appliance not heating
Programme selected without drying
The rinse aid integrated in tablets has dissolved too early
Plastic parts
Combined detergent products (2 in 1 / 3 in 1)
202_58300000104305_ara_en_b – 02.11.a
Remedial action
Advise customer
Advise customer, refer to function of the heat
exchanger; if required, connect the appliance
to cold-water supply
Check heating circuit according to circuit diagrams, note
pressure switch on the instantaneous water heater (the
circulation pump cannot build up adequate pressure if
there is insufficient water in the appliance).
Advise customer, quick programme is without drying
cycle, drying level option is too low
Advise customer, tablet is unsuitable for this
programme
Plastics retain very little heat and have a hydrophobic
surface which is difficult to moisten.
As a result, droplets will form during drying.
Advise customer, recommend separate detergent
products (separate rinse aid and detergent)
Seite 54 von 56