Programme Selector Switch; Setting The Hardness Range; Reset - Bosch SRU53E05AU Repair Instructions

3.5

Programme selector switch

3.5.1 Intensive 70°
The programme consists of a prerinse at 50°, wash cycle at 70°, two
intermediate rinse cycles, final rinse at 70° and a drying cycle. Until
the temperature is reached, rinsing occurs in the bottom basket only.
3.5.2 Normal 65°
The programme consists of a prerinse, a wash cycle at 65°, two inter-
mediate rinse cycles, final rinse at 70° and a drying cycle.
3.5.3 ECO 50°
The programme consists of a wash cycle at 50°, one intermediate
rinse cycle, final rinse at 66° and a drying cycle. Until the temperature
is reached, rinsing occurs in the bottom basket only.
3.5.4 Gentle 40°
The programme consists of a prerinse cycle, a wash cycle at 40°, one
intermediate rinse cycle, final rinse at 55° and a drying cycle.
3.5.5 Quick 35°/45°
The programme consists of a wash cycle at 35°/45°, one intermediate
rinse cycle, final rinse at 55° without drying.
815_58300000120057_ara_en_d.doc – 25.05.11
3.5.6 Prerinse
The programme consists of a prerinse only.
3.6

Setting the hardness range

Rotate the switch to position 9 (one position to the left), press and
hold down the main switch until the current setting lights up on the
display and then release the main switch. The low salt LED flashes.
Rotate the switch to set the hardness range between 0 and 2. When
the appliance is switched off, the value is saved. (Table below)
°dH °fH °Clarke
0 0–6 0–11 0–8
1 7–14 12–25 9–18
2* 15–21 26–37 19–26
3 22–35 38–60 27–44
* Standard setting = 2
3.7

Reset

These appliances are reset by an additional position on the rotary
switch. As a result, the reset starts 3 sec. after the switch was moved
to this position.
The water drains for one minute and the electronics module is again
ready for a new programme.
mmol/l LEDs
L1 L2
0–1.1
1.2–2.5
2.6–3.7
3.8–6.2
Seite 6 von 60
L3