Table of Contents
Advertisement
28. Decal Kit, Platform, ANSI
(JLG Part No. 1001071356)
29. Decal Kit, Powerpack, ANSI
(JLG Part No. 1001071602)
30. Decal Kit, Accessory Tray, ANSI
(JLG Part No. 1001071358)
31. Drill Strap Kit (JLG Part No. 1001071361)
32. Drill Socket Kit (JLG Part No. 1001071362)
33. Replacement Manual (JLG Part No. 1001071360)
34. Replacement Pouch Rivets (JLG Part No. 1001071339)
35. CSA Kit (JLG Part No. 1001071338)
1-877-254-3876
1-877-2-LIFTPOD
SECTION 6 - SERVICE AND MAINTENANCE
6.6
Decal Replacement
All decals must be mounted to the machine as specified and be
clearly legible.
Please see Figure 5-1. to Figure 5-4 and refer to Table 5-1. for
positions and JLG part numbers.
To replace a damaged decal, first remove it completely, without
damaging the underlying surface.
Remove any remaining adhesive with a suitable solvent. Test sol-
vent on inconspicuous area first, to ensure it does not mark or
damage the underlying surface finish.
SURFACE DAMAGE COULD RESULT IN CORROSION AND STRUCTURAL
DAMAGE.
Before applying new decal, ensure the surface is clean and dry.
Remove backing paper, apply decal along one edge then seat it
gently and evenly.
If there are any air bubbles, work them gently towards the edge
with a clean cloth.
Pressure sensitive adhesive reaches full strength after a several
days.
LIFTPOD by JLG
www.liftpod.com
NOTICE
1001070451
6-11
Advertisement
Table of Contents
