Table of Contents
Advertisement
SECTION 3 - MACHINE OPERATION
Fully Assembled Maneuvering
There are two ways to move the assembled machine:
PUSHED UPRIGHT
The machine can be pushed around using the built-in wheels and
castor. The floor is required to be smooth, level, clean and dry.
There can be no significant load on the machine while it is being
rolled around, or the swivel castor will retract automatically.
Figure 3-22. Activate the handle to extend the swivel
Lift the handle to engage the swivel castor.
The machine is easily positioned as required.
1001070451
3-18
castor
The swivel castor underneath the step plate toggles out of the way
when loaded, and the machine rests securely on the rear wheels
and two adjustable feet.
PUSHED TILTED OVER
The machine can be tilted over and maneuvered as shown in
Figure 3-23.
Figure 3-23. Maneuvering when tilted back
NOTE: Ensure powerpack and tool tray are securely attached
and tool tray and platform are empty before moving.
LIFTPOD by JLG
www.liftpod.com
1-877-254-3876
1-877-2-LIFTPOD
Advertisement
Table of Contents
