Configuration / Address Space; Configuring - Siemens Simatic ET 200SP Manual

Configuration / address space

4.1

Configuring

Introduction
To configure the AI Energy Meter HF after connecting it, use configuration software such as
STEP 7 (TIA Portal). In addition, you can also change numerous parameters of the
AI Energy Meter HF in RUN via the user program.
Configuring
You configure the AI Energy Meter HF with:
● STEP 7 (TIA Portal) as of V15 and HSP0253
● GSD file for PROFIBUS or PROFINET
Note
Consistency check of the parameter assignment only with STEP 7
If you configure the AI Energy Meter HF using STEP 7 (TIA Portal), STEP 7 (TIA Portal)
already checks the various parameters for consistency while they are being entered.
If you configure the AI Energy Meter HF using a GSD file, a consistency check is not carried
out. The module does not recognize incorrect entries until after the parameter data record
has been transferred. If the module recognizes an invalid parameter, the module rejects the
complete data record.
Preferably use STEP 7 (TIA Portal) to configure the AI Energy Meter HF.
The following instructions show the theoretical procedure for configuring the
AI Energy Meter HF with STEP 7 (TIA Portal) V15 or higher with HSP0253.
1. Select the ET 200SP distributed I/O system you are using in the hardware catalog.
2. Insert the module into your station.
3. Open the device view of the ET 200SP and insert the AI Energy Meter HF.
4. Configure the AI Energy Meter HF to suit your requirements.
Once the configuration has been compiled without errors, you can download the
configuration to the CPU and commission the ET 200SP station while the
Analog input module AI Energy Meter 480VAC/CT HF (6ES7134-6PA00-0CU0)
Manual, 07/2018, A5E42674880-AA
AI Energy Meter HF is running.
4
31