Siemens Simatic ET 200SP Manual page 157

Parameter data records
A.3 Structure of the parameter data record 129 for limit monitoring
The following table shows the module-specific error codes and their meaning for the
parameter data record 129.
Error code in STATUS parameter
(hexadecimal)
Byte 0 Byte 1 Byte 2
DF 80 B0
DF 80 B1
DF 80 B2
DF 80 E0
DF 80 E0
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
156
Meaning
Byte 3
00 Number of the data record unknown
01 Length of the data record incorrect
00 Slot invalid or cannot be accessed.
01 Incorrect version
02 Error in the header information
01 Reserved bits are not 0.
31 "Length of the parameter block" invalid.
32 "Number of parameter blocks" invalid.
33 "ID of the measured value for limit moni-
toring" invalid.
34 Parameters for monitoring the limits
invalid
35 "Number of limit" in 'Monitoring assigned
multiple times' parameter
36 "Hysteresis for limit monitoring" invalid
37 "Limit" invalid.
38 "Delay time for limit monitoring" invalid.
Analog input module AI Energy Meter 480VAC/CT HF (6ES7134-6PA00-0CU0)
Solution
Enter a valid number for the data record.
Enter a valid value for the data record
length.
Check the station whether the module is
plugged or drawn.
Check the assigned values for the pa-
rameters of the WRREC instruction
Check Byte 0. Enter valid values.
Check Bytes 1 and 2. Correct the length
and number of the parameter blocks.
Check bytes 3, 13, 23, 33...163 and set
the reserved bits back to 0.
Check Byte 1. Length = 10 bytes
Check Byte 2. Enter valid values.
Check Bytes 4 and 5. Enter valid values.
Check bits 0...3 in Byte 6. Enter valid
values.
Check bits 0...3 in Byte 6. Do not use
limit number several times.
Check Byte 7. Enter valid values.
Check Byte 8...11. Enter valid values.
Check Byte 12. Enter valid values.
Manual, 07/2018, A5E42674880-AA