Using The Hd/Sd Sdi Terminal; Using The Hdmi Out Terminal - Canon EOS C500 PL Instruction Manual

• Because this setting takes priority, the [
available.

Using the HD/SD SDI Terminal

The digital signal output from the HD/SD SDI terminal includes the video
signal, audio signal and time code signal. If necessary, perform the
following procedure to change the output to HD or SD*. Turning the
output off will conserve the camera's power.
* Not available for 24.00 Hz recordings.
Operating modes:
1 Open the [Output] submenu.
[ 4K/2K/MXF Setup] (in
2 Select the desired option and then press SET.
• If you selected [SD], you can select the SD resizing method (A 148).
• If necessary, adjust the scan mode and resizing method with the [
[Scan Mode] and [
configuration, the scan mode may be set automatically.
• If necessary, you can superimpose the onscreen displays on the video displayed on the external monitor
(A 149).
NOTES
• When you output from the HD/SD SDI terminal video in HD that was shot with Canon Log gamma, you can
apply a LUT (A 146).

Using the HDMI OUT Terminal

TM
The HDMI OUT terminal also offers a digital connection and outputs both a video and audio signal. The output
signal will automatically switch to HD or SD* depending on the capability of the external monitor. You can select
the resizing method (A 63) when the camera outputs HD video during 4K or 2K mode.
* Not available for 24.00 Hz recordings.
NOTES
• Correct operation cannot be guaranteed when connecting the camera to DVI monitors.
• Video may not be output correctly depending on the monitor. In such case, use another terminal.
• The HDMI OUT terminal is output only. Do not connect the camera to another device's output terminal using
the HDMI OUT terminal as this will cause a malfunction.
• If necessary, you can superimpose the onscreen displays on the video displayed on the external monitor
(A 149).
• You can select the SD resizing method (A 148).
4K/2K/MXF] > [MON. 1 & 2] > [LUT] setting will not be
mode) or [¢ Video Setup] (in
4K/2K/MXF Setup] > [Resize MXF Output] settings. Depending on the video
Connecting to an External Monitor
[ 4K/2K/MXF Setup]
HD/SD SDI]
[
[Output]
[HD]
mode) > [HD/SD SDI] > [Output]
4K/2K/MXF Setup] > [HD/SD SDI] >
147