Safety Summary; Signal Word Definitions; General Safety Precautions - Will Burt NIGHT SCAN Operator's Manual

'
N S U R C S O M
IGHT CAN NIVERSAL EMOTE ONTROL YSTEM PERATOR S ANUAL

Safety Summary

This section describes safety precautions for the Night Scan Universal Remote Control System.
These are recommended precautions that personnel must understand and apply throughout
many phases of installation and operation. Be sure the read and understand that entire manual,
and contact The Will-Burt Company with any questions, before performing any procedure
outlined in this manual.
For precautions pertaining to the Night Scan mast, see your Night Scan manual.

Signal Word Definitions

Per the ANSI Z535.4 standard, the following signal words and definitions are used to indicate
hazardous situations:
DANGER indicates an imminently hazardous situation that, if not avoided, will result in death or
serious injury.
WARNING indicates a potentially hazardous situation that, if not avoided, could result in death
or serious injury.
CAUTION indicates a potentially hazardous situation that, if not avoided, may result in minor or
moderate injury. It is also used to alert against unsafe practices.

General Safety Precautions

The following are general safety precautions that are not related to any specific procedures.
These are recommended precautions that personnel must understand and apply throughout
installation, operation, maintenance, and troubleshooting.
Electrocution Hazard! Contact with high voltage will result in death or serious injury. Observe
general safety precautions for handling equipment using high voltage. Do not locate or operate
mast near electrical lines, cables or other unwanted sources of electricity. Be sure to allow
sufficient clearance on all sides of the mast to allow for side sway. Do not operate mast in
lightning. Be certain electrical cables are undamaged and properly terminated. Always
disconnect power before performing service, repair or test operations.
Safety Instruction – Trained Personnel Only! Death or serious injury could result if proper
inspection, installation, operation and maintenance procedures are not observed. Installation,
operation and maintenance to be performed by trained and authorized personnel only. Proper
eye protection should be worn when servicing the mast.
TP-5543301-C v
July 2018