Night Scan Universal Remote Control System Installation; Select A Suitable Mounting Location; Unpack The Night Scan Universal Remote Control System; Install The Control Box - Will Burt NIGHT SCAN Operator's Manual

N S U
IGHT CAN NIVERSAL

2.5 Night Scan Universal Remote Control System Installation

This section describes how to install the Night Scan Universal Remote Control System. The
exact installation procedures may vary based on the installation environment. Hardware for
installing is not included with the Night Scan Universal Remote Control System.
These instructions assume that the mounting hole locations are not pre-drilled and that the
Control Box will be used as a template to drill these holes during installation. Alternatively, the
mounting hole locations could be found and pre-drilled using the installation dimensions
(Section 2.4). When pre-drilling the mounting holes, use care to ensure the mounting holes
properly align.

2.5.1.1 Select a Suitable Mounting Location

To select a suitable mounting location, consider the following:

The mounting structure must have sufficient room to mount the system.

The mounting structure must be level in all directions, solid, and capable of holding the
forces required by the bolts. Check the strength and rigidity of the mounting structure
where the system is to be attached. Reinforce as necessary.

The Control Box should be placed in a dry location where the operator is most likely to
be if an emergency stop is required.

Ensure the installation site allows cables to route between components without being
damaged. Cables will eventually need routed between the:
o Control Box and the Night Scan mast
o Control Box and customer power

2.5.1.2 Unpack the Night Scan Universal Remote Control System

Unpack the Night Scan Universal Remote Control System as follows:
1. Carefully open the box.
2. Inspect for any shipping damage. Notify the carrier if damage is evident.
3. Remove all loose components.

2.5.1.3 Install the Control Box

To install the Control Box:
1. Use the Control Box as a template and drill four holes into the mounting structure.
2. Attach the Control Box using four M7 (¼") fasteners. Torque all hardware as appropriate
for its material and size. The mounting hardware must include proper means to resist
vibration loosening such as thread-locking compound or locking hardware.
2-4
R C S
EMOTE ONTROL YSTEM
'
O M
PERATOR S ANUAL
TP-5543301-C
July 2018