Wireless Hhrc Pairing; Figure 4-1 Remove Power To Receiver - Will Burt NIGHT SCAN Operator's Manual

4.5 Wireless HHRC Pairing

This section describes pairing a Wireless HHRC with the Receiver in the Control Box. Typically,
the Wireless HHRC will ship already paired to the Receiver in the Control Box. This procedure is
only needed when replacing the Wireless HHRC or adding a second Wireless HHRC.
Safety Instruction! If pairing is performed when the Wireless HHRC has a low battery, it may
appear that the pairing works, however it may not work. Replace the battery and repeat the
pairing procedure. This is related to a safety precaution.
To pair the Wireless HRHC:
1. Turn the Selector Switch to "TETHERED CONTROLLER" to remove power from the
Receiver (Figure 4-1) and open the Control Box.
Alternatively, open the Control Box and remove power from the Receiver by removing
the fuse.
Selector Switch
TP-5543301-C
July 2018
N S U
IGHT CAN NIVERSAL

Figure 4-1 Remove Power to Receiver

R C S
EMOTE ONTROL YSTEM
Receiver
Selector
Switch
Receiver and Fuse
'
O M
PERATOR S ANUAL
Fuse
4-3