Test The Installation - Will Burt NIGHT SCAN Operator's Manual

N S U
IGHT CAN NIVERSAL

2.6 Test the Installation

Follow all precautions while testing the Night Scan Universal Remote Control System
installation. See Section 3 for additional details on these procedures.
To test the installation:
1. Review the Pre-Operation Check (Section 3.1).
2. Ensure the vehicle parking brake is engaged.
3. Ensure there are no obstructions overhead.
4. Ensure the Selector Switch is in the "WIRELESS CONTROLLER" position.
Note: For operation with the optional Wired HHRC, move the Selector Switch to the
"TETHERED CONTROLLER" position.
5. Ensure the "E-STOP"
pulled out.
6. Press the green "START/ON"
7. Extend the mast.
8. Turn the lights on and off.
9. Pan and tilt the light banks.
10. If an optional strobe/beacon light is equipped, turn the strobe/beacon light on and off.
11. Stow the mast.
2-6
R C S
EMOTE ONTROL YSTEM
buttons on both the Wireless Remote and Control Box are
button until "READY" is shown on the Display.
'
O M
PERATOR S ANUAL
TP-5543301-C
July 2018