Junction Box Controls; Quick Reference - Will Burt NIGHT SCAN Operator's Manual

3.4 Junction Box Controls

Symbol
E-STOP Button. If an emergency stop
is required at any time, press the
E-STOP button. This will disconnect
power from the unit and cause all air to
be exhausted from the mast.
WIRELESS. Selecting WIRELESS
switches control functions to the
Wireless HHRC.

3.5 Quick Reference

The following is a quick summary of operation of the Night Scan using the Wireless HHRC. For
detailed operation instructions, see your Night Scan operator's manual. If necessary, contact
The Will-Burt Company to obtain this document.
If an emergency stop is required at any time, press the "E-STOP"
the unit from power and cause all air to be exhausted from the mast.
Note: The "E-STOP"
tethered operation, the "E-STOP"
button on the Control Box may be used for either wired or tethered operation.
To re-initiate, turn the "E-STOP"
In general, to operate the Night Scan with the Wireless HHRC:
1. Ensure the vehicle parking brake is engaged.
2. Ensure there are no obstructions overhead.
3. Ensure the Selector Switch is in the "WIRELESS CONTROLLER" position.
Note: For operation with the optional Wired HHRC, move the Selector Switch to the
"TETHERED CONTROLLER" position.
4. Ensure the "E-STOP"
pulled out.
5. Press the green "START/ON"
TP-5543301-C
July 2018
N S U
IGHT CAN NIVERSAL
Function
Emergency Stop
button on the Wireless Controller only works for wireless operation. For
button on the Control Box must be used. The "E-STOP"
button to pop out the "E-STOP"
buttons on both the Wireless Remote and Control Box are
button until "READY" is shown on the Display.
R C S
EMOTE ONTROL YSTEM
Symbol
START Button. Turns the system
on.
TETHERED. Selecting TETHERED
switches control to the optional
Wired HHRC.
button. This will disconnect
'
O M
PERATOR S ANUAL
Function
button.
3-5