Section 2 Installation; Pre-Installation Check - Will Burt NIGHT SCAN Operator's Manual

Section 2
This section describes the installation of the Night Scan Universal Remote Control System and
provides general procedures that must be followed to ensure a successful installation. Use care
to understand and follow all precautions while installing.

2.1 Pre-Installation Check

Before installing the Night Scan Universal Remote Control System, ensure:

All installers read and understand the entire installation procedure

All components are included (Section 1.6)

All required equipment is readily available (Section 2.2)

The mounting structure is level with sufficient room to mount the system (Section
2.5.1.1)

The vehicle is stationary

That the following precautions are understood and followed:
Mounting Structure Hazard! Before operation, be certain the mounting structure is capable of
resisting forces generated from all loading and environmental conditions including, but not
limited to system size and weight, payload size and weight, sail size, wind speed, and ice
loading. The mounting hardware must include proper means to resist vibration loosening such
as thread-locking compound or locking hardware. Mounting the system to a structure unable to
resist the forces generated from customer-specific loading scenario could result in death or
serious injury and could damage the system.
Trained Personnel Only! Only trained and qualified personnel should perform installation
procedures. Only a properly trained and qualified certified electrician should perform electric
installations. Death or serious injury could result if proper installation procedures are not
observed.
Safety Instruction – Mounting Instructions! Be sure to understand all mounting instructions.
The mounting hardware must include proper means to resist vibration loosening such as thread-
locking compound or locking hardware. Failure to follow mounting instructions can result in
death or injury.
Safety Instruction – Roof Access! If mast will be mounted to a vehicle, the operator must
provide safe means to access the roof of the vehicle during installation and maintenance.
TP-5543301-C
July 2018
N S U
IGHT CAN NIVERSAL
Installation
R C S
EMOTE ONTROL YSTEM
'
O M
PERATOR S ANUAL
2-1