Setting The Delay Time - Siemens SIMATIC HMI Operating Instructions Manual

Configuring the operating system

6.8 Setting the delay time

General information
Note
Changes during "Transfer" mode
If changes are made to the transfer settings when the HMI device is in "Transfer" mode or
while a project is running, the new settings will only take effect the next time a transfer or the
project is started.
This may occur if the Control Panel is opened to change the transfer properties in an active
project.
NOTICE
Transfer mode via channel 2
You can change the settings for the transfer.
The following steps are required:
• Close the project.
• Change the settings on the HMI device.
• Then return to "Transfer" mode.
See also
Changing the network configuration (Page 169)
6.8 Setting the delay time
Introduction
The project is opened following a delay time when the HMI device is switched on. The
Loader is displayed during the delay time.
Requirements
You have opened the "Transfer Settings" dialog box, "Directories" tab, by touching the
"Transfer"
162
icon.
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01