Siemens SIMATIC HMI Operating Instructions Manual page 117

Printing labeling strips
WinCC flexible comes with a range of labeling strip templates. You will find further
information regarding the location of the templates in the WinCC flexible Online Help.
Any printable and writable foil can be used as labeling strips. Use transparent foil so that the
LEDs of the function keys can be seen. The permitted thickness of the labeling strip is 0.13
mm. Paper should not be used as labeling strips.
Labeling strip dimensions
Procedure for attaching the labeling strips
The following steps apply for the initial attaching of labeling strips.
Proceed as follows:
1. Lay the HMI device on its reverse side.
2. Remove the label ① from the cover caps.
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01
Operator controls and displays
5.7 Labeling the function keys
117