Holding The Mobile Panel And Fixing It To The Wall - Siemens SIMATIC HMI Operating Instructions Manual

Operator controls and displays

5.8 Holding the mobile panel and fixing it to the wall

1. Unscrew both cover caps.
2. Pull the labeling strips out of the guides.
3. Inscribe the labeling strips in accordance with the system.
4. Push the labeling strips into the guides.
5. Screw both cover caps back on.
6. Place the label on to the cover caps.
Procedure for exchanging the labeling strips
Should the exchange of labeling strips become necessary, these can be reordered.
See also
Supplementary pack and other accessories (Page 20)
5.8 Holding the mobile panel and fixing it to the wall
Holding the HMI device
CAUTION
Rampdown
If the HMI device is logged onto an effective range and more than 5 seconds pass without it
recognizing the effective range, the enabling button is deactivated.
If a further 25 seconds pass without the HMI device recognizing the effective range, the
HMI device triggers a local rampdown.
Always align the HMI device towards the transponder.
118
Wait for the printed labeling strips to dry before you insert them.
Screwed on cover caps with inserted rubber seals satisfy degree of protection IP65.
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01